[*]Category's Question List
[0]Product FAQ Top
[#]Product Guide

Q.
How do I use the JaJa on the ibisPaint?


A.
The ibisPaint and the ibisPaint X supported the JaJa of the HEX3 from ver.2.7.0.
The JaJa can be used only on the iPad.
We’re going to explain here how to use the JaJa on the ibisPaint.
In addition, we assume that the JaJa is already turned on.
Please refer “QUICKSTART GUIDE” which attaches to the JaJa if you don’t know how to turn on the JaJa.

  1. Tap “+” button in the My Gallery and the canvas screen will appear.
  2. Tap the tool selection button which is the left most in the toolbar in the bottom of the screen.
  3. Tap the configuration button (it’s a gear icon) in showed tool selection popup and the Configuration window appears.
    4. Check whether “Digital Stylus” of the Configuration screen shows “Not Connected:HEX3 JaJa” or “Connected:HEX3 JaJa”.
  4. If it doesn’t show, tap the button and tap “HEX3 JaJa” button in shown popup.
  5. The text of the button changes to “Connected:HEX3 JaJa” if the JaJa is already turned on.

The preparation to use the JaJa completed.
The calibration isn’t necessary because the JaJa uses the touch panel for detection of the position of the pen.

Please do followings if you want to disconnect the JaJa.
  • Don’t use the JaJa two minutes.
  • Tap the “Connected:HEX3 JaJa” button in “Digital Stylus” of the Configuration window and tap the button except “HEX3 JaJa” button in shown popup.
  • Remove the battery of the JaJa

The JaJa has pressure sensitivity and the ibisPaint supports it on the brush tool, the eraser tool, the smudge tool, and the blur tool.
The property which responds to pressure sensitivity is changed by the type of the parameter.
- Dip Pen (Hard)
- Round Brush
The thickness (size) property is changed by pressure sensitivity.
- Other parameter types
The opacity property is changed by pressure sensitivity.

You can adjust the amount of change of the line by pressure sensitivity in the Configuration window.
“Thickness to Pressure” in “Digital Stylus” changes the amount of change of the thickness by pressure sensitivity. “Opacity to Pressure” in “Digital Stylus” changes the amount of change of the opacity by pressure sensitivity.

The JaJa has two buttons and you can assign the function to these.
You can configure the assignment function in “Button 1” and “Button 2” in the “Digital Stylus” of the Configuration window.
In the JaJa, upper button corresponds to “Button 1” and lower button corresponds to “Button 2”.
Assignable functions to buttons are below.
  • Brush/Eraser: Change the brush tool and the eraser tool.
  • Color picker: Start quick color picker mode.
  • Full Screen: Change the screen mode.
  • Zoom Fit: Reset the position and scale of the canvas.
  • Undo: Undo one time.
  • Redo: Redo one time.
  • Brush Window: Change the visible state of the Brush window.
  • Color Palette: Change the visible state of the Color Palette.
  • Layer Window: Change the visible state of the Layer Window.


Was the problem solved?

 It is solved.
 It is not solved. I inquire about it.


[*]Category's Question List
[0]Product FAQ Top
[#]Product Guide


Language